Tic-tack on a tie dye shirt

Place a ball of cotton T-shirt over a plain. Go back if you want to cross in front of the jersey, up and down if you cross on the back. Achieve the best results; use a cotton shirt in pure cotton 100 percent, as it marks better absorbed than a mixture of polyester and other synthetic materials. Use a pencil or a marker to draw the outline of a cross on the front or back of the T-shirt. A needle with strong thread of something Make a secure knot at the end of the line sewing thread along the lines that you relied on the cross on his shirt. You can use the points. Pull the cable into one end of the T-shirt, so that the contours of the cross before. While the cross removed from the pot and is on one side of the Son fulfilled when securing the wire have decreased with a knot at the end. Wrap a rubber band around the area of the cross, which has collected. Wrap the tape several times, until it is too narrow. Gather the rest of his shirt and wrap it with a rubber band. Place the rubber band three inches below the first into the rubber to the rest of the network to at the bottom of the shirt. Gather the rest of his shirt and wrap it with a rubber band. Place the rubber band three inches below the first into the rubber to the rest of the network to at the bottom of the shirt. Rubber gloves and mix the colors assigned preparation kits The ink-jet in the cross-section of the T-shirt, the first of the tread rubber Splash of color in different colors on the two remaining part of the shirt. Soak and wash the shirt as shown. Cut the rubber ring and the thread of his shirt to show a drawing of a cross to remove.